2005 Arctic Cat ATVs factory service and repair manual, Page 647Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 647

REPLACING SPEEDOMETER To replace the speedometer, use the following procedure1Remove the four nylon fasteners securing the
stud; then dislodge the locating studs from the giommets 6Secure the ignition switch with the retaining nut 3Remove the left-side
inner fender panel and disconnect the multi-pin speedometer connector; then route the speedomeier wiring harness up through
the opening in front of the steering post 7Connect the multi-pin connector; then install and secure the left-side inner fender