2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 27Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 27

7Apply oil to new filter O-ring and check to make sure it is positioned correctly; then install the new oil filterTighten
wipe it with clean cloth12Install the oil level stick until the threads touch engine caseNOTE: On the 400 auto500 auto650
H1, the oil level stick should not be threaded into the case for checking the oil levelNOTE: On the 650 V-Twin, the oil level
stick should be threaded into the case for checking the oil level ATV0100A 14Inspect the area around the drain plug and oil
filter for leaksSTRAINER NOTE: For servicing the oil strainer on the 650 V-Twin, see Center Crankcase Components in Section
3 To check the oil strainer, use the following procedure1Remove the skid plate2Remove the cap screws securing the oil strainer
cap; then remove the capAccount for the O-ring 13Remove the oil level stick; the engine oil level should be above the illustrated
"L" mark but not higher than the illustrated "F" mark ! CAUTION Do not over-fill the engine with oilAlways make sure that