2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 32Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 32

TAILLIGHT-BRAKELIGHT To replace the taillight-brakelight bulb, use the following procedure1Turn the bulb socket assembly
the housing and turn it clockwise to secureCHECKINGADJUSTING HEADLIGHT AIM The headlights can be adjusted vertically and
horizontallyThe geometric center of the HIGH beam light zone is to be used for vertical and horizontal aiming1Position the
ATV on level floor so the headlights are approximately 6.1 (20 ft) from an aiming surface (wall or similar aiming surface)NOTE:
There should be an average operating load on the ATV when adjusting the headlight aim Switches Each time the ATV is used,
switches should be checked for proper operationUse the following list for reference AIgnition switch engine will startBEmergency
stop switch engine will stop 2Measure the distance from the floor to the mid-point of each headlight3Using the measurements