2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 35Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 35

CUsing two open-end wrenches, remove lock nut (B) securing the shift rod to the upper shift axleDiscard the lock nutNOTE:
H1, install the left-side splash panelHInstall the seat4A.On the 650 V-Twin, loosen the two torx-head screws on the slotted
section of the linkage Electrical Connections The electrical connections should be checked periodically for proper functionIn
case of an electrical failure, check fuses, connections (for tightness, corrosion, damage), andor bulbsIf an electrical component
needs to be tested for proper function, see Section 5 Hydraulic Brake Systems ADJUSTING LINKAGE NOTE: Prior to attempting
to bleed the hydraulic auxiliary brake (remote reservoir type), the linkage must be checked for proper adjustment BHold the
shift lever in the position and make sure the shift arm is in the full-forward detent position; then tighten the two torx-head