2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 42Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 42

NOTE: Make sure the belt is at the top of the driven pulley (A) before checking belt deflection 4Disassemble the driven pulleySee
mm (0.004 in of shim pack change, belt deflection will change by approximately 1.45 mm (0.057 inShims are available in the
following sizes: 0.6 mm (0.024 in, 0.8 mm (0.031 in, 1.0 mm (0.039 in, and 1.4 mm (0.055 in ATV2061 7Assemble the driven
pulley (see Section 3, Servicing Right-Side Components, steps 1-5); then install the driven pulley, V-belt, and drive clutch
and verify that belt deflection is within specifications8Check the position of the Belt Failure Detection Switch (A) and
reset to the ON position (B) NOTE: If belt deflection is out of specifications, proceed to step 3If belt deflection is within