2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 43Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 43

10Connect the actuator lead and the Belt Failure Detection Switch lead; then install the air duct and secure with the clamps
the jam nut (B) ATV2062A NOTE: If the Belt Failure Detection Switch has been tripped to the OFF position, the V-belt cover
and switch assembly must be replaced and the V-Belt Failure Mode Clearing procedure (see Section 5) must be performed 9Install
the cover seal into the V-belt cover with the glue joint (A) as shown; then install the V-belt cover and tighten the cap
screws to specifications 2Turn the adjuster (C) until approximately 6.35 mm (14 in of free-play can be measured at the end