2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 54Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 54

(400Manual Transmission) Removing EngineTransmission 3-11 Top-Side Components3-14 Removing Top-Side Components 3-15 Left-Side
the engine Removing Engine Transmission ATV-0109 Many service procedures can be performed without removing the enginetransmission
from the frameClosely observe the note introducing each sub-section for this important information 6Remove the front and
rear fender panels (see Section 8)7On VP models, turn the gas tank valve to the OFF position; then remove the fuel hose and
vent hoseOn FIS models, disconnect fuel hose (1), carburetor vent hose (2), and the fuel pump vacuum hose (3) from the carburetor
AT THIS POINT If the technician's objective is to servicereplace left-side cover oil seals (3), front output joint oil seal
(1), rear output joint oil seal (1), andor the oil strainer (from beneath the engine transmission), the enginetransmission
does not have to be removed from the frame Secure the ATV on support stand to elevate the wheels ! WARNING Make sure the
ATV is solidly supported on the support stand to avoid injury 1Remove the seat 8On VP models, remove the gas tank9On VP models,