2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 61Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 61

AT THIS POINT To service center crankcase components only, proceed to Removing Left-Side Components Left-Side Components
rubber bands to avoid damaging the rod or install the Connecting Rod Holder (pn 0444-006) 1Remove the two cap screws securing
the starter to the crankcase; then remove the starter2Remove the four cap screws securing the recoil cover to the left-side
cover; then remove recoil cover ! CAUTION Do not allow the connecting rod to go down inside the crankcaseIf the rod is down
inside the crankcase and the crankshaft is rotated, severe damage will result NOTE: If the existing rings will not be replaced
with new rings, note the location of each ring for proper installationWhen replacing with new rings, replace as complete
set onlyIf the piston rings must be removed, remove them in this sequence AStarting with the top ring, slide one end of the
ring out of the ring-grooveBRemove each ring by working it toward the dome of the piston while rotating it out of the grooveCC942