2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 160Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 160

CRANK BALANCER DRIVEN GEAR KEY 12345678 Balancer Shaft Washer Driven Gear #1 Driven Gear #2 Spring Key Pin Washer Assembling
for pins and springs3Remove driven gear #2 from gear #1; then account for large washer and keyInspecting 1Inspect the gear,
pins, and keyway for wear2Inspect the springs for damage or fatigueAssembling 1Place driven gear #2 into driven gear #1;
then align the alignment marks of driven gear #1 and driven gear #22Using pair of needle-nose pliers, insert each spring
part way into the slot; then install pin and push the springpin assembly into the slot3Place the key and the large washer
into position on the balancer shaft4Place the driven gear #1 assembly onto the balancer shaft; then place the large and small