2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 166Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 166

18Making sure the eight movable drive face rollers are in position, pinch the V-belt together near its center and slide the
separated, insert wedge (approximately 38 inthick) between the facesRelease the inner faceMD1338 NOTE: At this point, the
wedge can be removed from between the driven pulley faces 17Place the V-belt into position on the driven pulley and over
the front shaft 19Rotate the V-belt and drivedriven assemblies until the V-belt is flush with the top of the driven pulley20Install
two alignment pins and place the V-belt cover gasket into position on the clutch coverInstall the V-belt cover noting the