2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 168Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 168

9Install two alignment pins and place the left-side cover gasket into positionInstall the left-side coverNoting the different-lengthed
the nut wlock washer to specifications ATV-1085B NOTE: Note the direction of the exhaust side of the piston (5) for correct
ring end gap orientationMD1304 BInstall the compression rings (1 and 2) so the letter on the top surface of each ring faces
the dome of the pistonRotate the rings until the ring end gaps are on directly opposite sides of the piston according to
the illustrationNOTE: The chrome (silver) ring should be installed in the top position 11Tighten the cap screws (from step
9) in crisscross pattern to specifications12Place the gasket, recoil starter assembly, and cover into position on the left-side