2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 186Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 186

BRemove each ring by working it toward the dome of the piston while rotating it out of the groove AT THIS POINT To service
of components may be necessaryNote the AT THIS POINT information in each sub-sectionCC621 NOTE: The enginetransmission does
not have to be removed from the frame for this procedure 4Remove the two cap screws securing the speed sensor housing; then
remove the housingAccount for the gasket and two seal washers Removing Left-Side Components ARecoil Starter BWater Pump CCover
DRotorFlywheel 1Remove the four cap screws securing the recoil starter assembly to the left-side cover; then remove the recoil
starterAccount for the gasket AT THIS POINT To service the recoil starter, see Servicing Left-Side Components sub-section
5Loosen the clamps securing the coolant hose to the water pump; then remove the crossover tube from the cylinder headAccount