2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 203Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 203

NOTE: To produce the proper 60 cross-hatch pattern, use low RPM drill (600 RPM) at the rate of 30 strokes per minuteIf honing
of six measurementsThe trueness (out-of-roundness) is the difference between the highest and lowest readingMaximum trueness
(out-of-roundness) must not exceed specifications 4If any measurement exceeds the limit, replace the cylinder and pistonMeasuring
Camshaft Runout NOTE: If the camshaft is out of tolerance, it must be replaced 1Place the camshaft on set of blocks; then
position the dial indicator contact point against the shaft and zero the indicator 2Wash the cylinder in parts-cleaning solvent3Inspect
the cylinder for pitting, scoring, scuffing, and corrosionIf marks are found, repair the surface using ball hone 2Rotate