2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 214Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 214

ATV-0104 Correcting Tooth Contact NOTE: If tooth contact pattern is comparable to the correct pattern illustration, no correction
must not exceed specificationsMeasuring Connecting Rod (Big End Side-to-Side) NOTE: To correct tooth contact, steps and (with
NOTE) of "Correcting Backlash" must be followed and the above "Tooth ContactShim Correction" chart must be consulted ! CAUTION
After correcting tooth contact, backlash must again be checked and corrected (if necessary)Continue the correcting backlashcorrecting
tooth contact procedures until they are both within tolerance values 1Push the lower end of the connecting rod to one side
of the crankshaft journal2Using feeler gauge, measure the gap between the connecting rod and crankshaft journal CRANKSHAFT