2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 215Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 215

Measuring Connecting Rod (Big End Width) 1Using calipers, measure the width of the connecting rod at the big-end bearing2Acceptable
the reverse gear dog2Remove the reverse gear dog; then remove the circlip securing the reverse driven gear3Remove the reverse
driven gear and account for the washer, bushing, and bearing4Remove the low driven gear washer and lock washers; then remove
the low driven gearAccount for the bushing and bearing5Remove the washer; then remove the circlip securing the sliding dogRemove
the sliding dog6Remove the high driven gear circlip; then remove the high driven gearAccount for the washer, bushing, and
bearing ! CAUTION Care should be taken to support the connecting rod when rotating the crankshaft 4Maximum runout must not
exceed specificationsNOTE: Proceed to check runout on the other end of the crankshaft by positioning the indicator contact