2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 220Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 220

AT THIS POINT After completing center crankcase components, proceed to Installing Right-Side Components, to Installing Left-Side
onto the crank balancer shaftGrease the pin and insert it into the shaft; then install the drive gear making sure the raised
side of the gear is facing toward the insideSecure the gear with the cap screw (threads coated with red Loctite #271) and
the washerTighten the cap screw to specifications 2Install the secondary shaft bearing housing making sure the two alignment
pins are properly positionedTighten the Allen-head screws securelyCC712 5Grease the driven gear pin and insert it into the