2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 243Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 243

BRemove each ring by working it toward the dome of the piston while rotating it out of the groove AT THIS POINT To service
The enginetransmission does not have to be removed from the frame for this procedure NOTE: Support the connecting rod with
rubber bands to avoid damaging the rod or install the Connecting Rod Holder (pn 0444-006) ! CAUTION Do not allow the connecting
rod to go down inside the crankcaseIf the rod is down inside the crankcase and the crankshaft is rotated, severe damage will
result Removing Left-Side Components ARecoil Starter BHiLow Shifter Assembly CSpeed Sensor Housing DCover NOTE: If the existing
rings will not be replaced with new rings, note the location of each ring for proper installationWhen replacing with new
rings, replace as complete set onlyIf the piston rings must be removed, remove them in this sequence 1Remove the cap screws
securing the recoil starter assembly to the left-side cover; then remove the recoil starter AStarting with the top ring,