2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 268Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 268

Cleaning and Inspecting NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
the starter handle and pull the rope out of the handle; then untie the knot in the rope and remove the handleNOTE: Do not
remove the spiral spring unless replacement is necessaryIt should be visually inspected in place to save timeIf replacement
is necessary, follow steps 9-10B606D 9Remove the spiral spring from the case by lifting the spring end up and outHold the
remainder of the spring with thumbs and alternately release each thumb to allow the spring to gradually release from the
case10Unwind the rope from the reel and remove the rope 2Insert the rope through the hole in the reel and tie knot in the
end; then wrap the rope counterclockwise around the reel leaving approximately 50 cm (20 in of rope free of the reel3Apply
low-temperature grease to the spring and hub4Thread the end of the rope through the guide hole of the case; then thread the
rope through the handle and secure it with double knotInstall the protective cover into the handle5Align the inner hook of