2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 341Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 341

ATV2073 2Maximum diameter must not exceed specificationsNOTE: Always tighten connecting rod cap nuts to the specified torque
be within specificationsIf there is an "O," the big end inside diameter should be within specifications ATV2074 6Place the
crankshaft on set of blocks; then mount dial indicator and base on the surface plateATV2072 4Measure the crank pin diameter
(A) and check the crankshaft marking (B)If no mark is on the crankshaft, the crank pin diameter should be within specificationsIf
the crankshaft is marked with "O," crank pin diameter should be within specificationsNOTE: If the crank pin diameter does
not coincide with the marking, make new mark that coincides with the measurement 7Slowly turn the crankshaft and note the