2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 342Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 342

2Install and tighten four nut-holding bolts (A) in the four threaded holesSee illustration for location of assembly components
roughness is found, proceed to Installing Output DriveDriven Bevel Gears in this sub-section 3Loosen the bevel gear (B) using
an Allen wrench while holding the housing (A) in vise; then continue to turn the bevel gear (about 4-5 turns) until the retainer
nut is free of the holding bolts 1Look through the bolt hole (B) in the drive housing (A); then rotate the drive bevel gear
(C) until notch in the inner bearing retainer nut can be seen 4Loosen the holding bolts, removing one; then using brass or