2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 343Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 343

DISASSEMBLING OUTPUT DRIVEN BEVEL GEAR ASSEMBLY AT THIS POINT If no abnormal chipping or bearing roughness is found, proceed
then set the housing assembly (A) on the holder, tighten holder nuts (D), and compress the damping spring (E) 2Remove the
circlip (A); then loosen and remove the holder nuts and spring compressor component of the toolKX301 3Remove the spring holder
(B), spring (C), cam damper (D), and the driven bevel gear (E) 7Remove the outer ball bearing (A) using suitable seal and