2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 346Get this manual
NOTE: Do not move the connecting rod with plastigauge installed or the reading will be compromised 8Remove the connecting
and inserts; then assemble on the crankshaft using clean, molybdenum disulfide oil on the inserts (A)Make sure that the "OUT"
marks (B) on both connecting rods are directed towards the outside of the crankshaft and the grooves (C) of the cap and connecting
rod are on the same side 13Install spacer, toothed washer (A), and the circlip on the driven shaft 10Install the crankshaft
assembly in the right crankcase half11Using press, install the driven shaft in the crankcase until it is bottomed; then install