2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 355Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 355

2Install the two bevel washers (A) with the concave side directed towards the driven pulley; then use the pulley holder (B)
recess from the plate surface to the clutch collar CD902 KX349 4Check that drive belt deflection is within specifications
(see Section 2) 5Remove the clutch holding tool (A); then install the three cap screws and tighten the drive clutch cover
to specifications using crisscross pattern CIf the measurement is less than 14.55 mm (0.573 in, install red drive clutch
cover (pn 3201-162)If the measurement is greater than 15.65 mm (0.616 in, install blue drive clutch cover (pn 3201-163)If
the length cannot be obtained, install the drive clutch assembly7Tighten the clutch cover bolts to specifications using crisscross