2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 393Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 393

4While holding the bearing housing assembly in position on the engine, slowly rotate the impeller until the impellershaft
the proper amount of recommended oil6Fill the cooling system with the proper amount of recommended coolantNOTE: While the
cooling system is being filled, air pockets may develop; therefore, run the engine for five minutes after the initial fill,
shut the engine off, and then fill the cooling system 1Secure the water pump to the engine with the two cap screws tightened
securely; then tighten the two Phillips-head cap screws securely 7Check the entire cooling system for leakage ! CAUTION After
operating the ATV for the initial 5-10 minutes, stop the engine, allow the engine to cool down, and check the coolant levelAdd
coolant as necessary Water Pump Alternator Cover (650 V-Twin) NOTE: Check for water pump seal leakage by examining drain
catch tank (A)CC785A 2Connect the two coolant hoses to the water pump and secure with the clamps3From inside the left-front