2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 401Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 401

NOTE: Electrolyte should be at room temperature before fillingDo not use water or any other liquid to activate battery !
line4Trickle-charge the battery at 1.4 amps for 8-10 hours5After charging, check electrolyte level and fill with DISTILLED
WATER as necessary; then install the vent plugsWash off acid spillage with water and dry the battery ! CAUTION Before installing
the battery, make sure the ignition switch is in the OFF position Accessory ReceptacleConnector (400500650 H1650 V-Twin)
NOTE: This test procedure is for either the receptacle or the connector 6Place the battery into position in the ATV and secure;
then connect the vent hose to the battery7Connect cables to the proper terminals: positive cable to the positive terminal
(+) and negative cable to the negative terminal (-)Connect the negative cable last VOLTAGE ! CAUTION Connecting cables in
reverse (positive to negative and negative to positive) can cause serious damage to the electrical system 1Turn the ignition