2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 404Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 404

3On the coolant temperature switch when the water temperature reaches 112-118 (234-244 F), the meter should read closed circuit4On
wire 3The meter must show less than ohm Fan Motor The connector is located behind the fan assemblyNOTE: The ignition switch
must be in the ON position NOTE: If the meter shows more than ohm of resistance, troubleshoot or replace the switchcomponent,
the connector, or the switch wiring harnessNOTE: To determine if the fan motor is good, connect the blue wire from the fan
connector to 12 volt DC power supply; then connect the black wire from the fan connector to groundThe fan should operate
VOLTAGE (Main Harness Connector to Fan Motor) 1Set the meter selector to the DC Voltage position2Connect the red tester lead
to the blackred wire (the black 2-prong at the fan motor); then connect the black tester lead to ground3The meter must show
battery voltageNOTE: If the meter shows no battery voltage, troubleshoot the battery, fuse, motor, or the main wiring harnessNOTE: