2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 407Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 407

Secondary Winding 1Remove the plug cap from the high tension lead; then connect the red tester lead to the high tension lead2On
connect the black tester lead to the other end of the cap PrimaryCDI NOTE: The CDI is located beneath the seat near the battery
1Set the meter selector to the DC Voltage position; then disconnect the bluewhite primary wire from the coil2Connect the
red tester lead to the primary wire; then connect the black tester lead to ground3Crank the engine over using the electric
starter4The meter reading must be within specificationAR603D 2The meter reading must be within specificationNOTE: If the
meter does not read as specified, replace the spark plug cap Indicator Lights PEAK VOLTAGE (400) NOTE: All of the peak voltage
tests should be made using the Fluke Model 73 Multimeter (pn 0644-191) with Peak Voltage Reading Adapter (pn 0644-307)If
any other type of tester is used, readings may vary due to internal circuitryNOTE: The battery must be at full charge for
these tests To access the indicator light connectors for testing purposes, use the following procedure1Remove the two reinstallable