2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 410Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 410

NOTE: If the meter shows no battery voltage, troubleshoot the battery or the main wiring harness RESISTANCE Handlebar Control
meter must show less than ohm8Connect the red tester lead to the red wire; then connect the black tester lead to the gray
wire9The meter must show less than ohm10With the switch in the OFF position, connect the red tester lead to the red wire
and the black tester lead to each of the remaining wiresThe meter must show an open circuit on all wires11On the 650 H1650
V-Twin, connect the red tester lead to the red wire and the black tester lead to the brown wireWith the switch in the ON
position, the meter must show 980-1020 ohmsNOTE: If the meter shows more than ohm of resistance, troubleshoot or replace
the switchcomponent, the connector, or the switch wiring harness ! CAUTION Always disconnect the battery when performing
resistance tests to avoid damaging the multimeter RESISTANCE (HI Beam) 1Set the meter selector to the OHMS position2Connect
the red tester lead to the yellow wire; then connect the black tester lead to the gray wire3With the dimmer switch in the