2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 413Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 413

3With the engine running at the specified RPM, all wire tests must show 60 A.Cvolts ! CAUTION Do not run the engine at high
at constant 5000 RPM (with the headlights on), the meter must show 14-15.5 DC volts ! CAUTION Always disconnect the battery
when performing resistance tests to avoid damaging the multimeter 1Set the meter selector to the OHMS position2Connect the
red tester lead to the green wire; then connect the black tester lead to the blue wireThe meter reading must be within specificationRESISTANCE
(Source Coil) ! CAUTION Do not run the engine at high RPM for more than 10 seconds NOTE: If voltage is lower than specified,
test stator coilno load 1Set the meter selector to the OHMS position2Connect the red tester lead to the yellow wire; then
connect the black tester lead to the white wire3The meter reading must be within specificationNOTE: If the meter shows other
than specified in any resistance test, replace the stator assembly VOLTAGE (Stator CoilNo Load) The connector is the black