2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 414Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 414

NOTE: The battery must be at full charge for these tests 3Crank the engine over using the electric starter4The meter reading
reading must be within specificationPEAK VOLTAGE (500650 H1) NOTE: All of the peak voltage tests should be made using the
Fluke Model 73 Multimeter (pn 0644-191) with Peak Voltage Reading Adapter (pn 0644-307)If any other type of tester is used,
readings may vary due to internal circuitryNOTE: The battery must be at full charge for these tests ! CAUTION Do not run
the engine at high RPM for more than 10 seconds NOTE: If voltage is lower than specified, test stator coilno load VOLTAGE
(Stator CoilNo Load) The connector is the white one on the right side behind the engineNOTE: Test the connector that comes
from the engine Magneto Coil (Trigger) 1Set the meter selector to the DC Voltage position2Connect the red tester lead to
the green wire; then connect the black tester lead to the blue wire3Crank the engine over using the electric starter4The
meter reading must be within specificationMagneto Coil (Source) 1Set the meter selector to the A.CVoltage position2Test between