2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 420Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 420

NOTE: If the meter showed battery voltage but the starter did not operate or operated slowly, inspect battery voltage (at
access the terminal, slide the boot awayNOTE: The ignition switch must be in the ON position, the emergency stop switch in
the RUN position, the reverse lever (on manual transmission models) in the FORWARD position, and the shift lever (on automatic
transmission models) in the NEUTRAL position 1Set the meter selector to the DC Voltage position2Connect the red tester lead
to the starter terminal; then connect the black tester lead to ground3With the starter button depressed, the meter must show
battery voltage and the starter motor should operate NOTE: Make sure that the ignition switch is in the ON position, transmission
in neutral, brake lock released, and the emergency stop switch in the RUN position 3Depress the starter button while observing
the multimeterThe multimeter should drop to volts and "click" should be heard from the relayNOTE: If "click" is heard and