2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 422Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 422

VOLTAGE NOTE: Perform this test in turn on the main harness side of all four connectorsAlso, the ignition switch must be
the two inside connectors (HI beam)The meter must show battery voltageNOTE: If battery voltage is not shown in any test,
inspect the fuses, battery, main wiring harness, connectors, or the left handlebar switch VOLTAGE (Brakelight) NOTE: Perform
this test on the main harness side of the connectorAlso, the ignition switch should be in the ON position and the brake (either
foot pedal or hand lever) must be appliedNOTE: Make sure the brake lever (hand) and brake pedal (auxiliary) are properly
adjusted for this procedure TaillightBrakelight The connector is the 3-prong one located under the rear fender assemblyBULB
VERIFICATION NOTE: Perform this test on the taillight-brakelight side of the connectorAlso, 12-volt external power supply
(jumper) will be needed 1Set the meter selector to the DC Voltage position2Connect the red tester lead to the redblue wire;
then connect the black tester lead to the black wire3With either brake applied, the meter must show battery voltageNOTE: