2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 424Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 424

100-Hour Belt Inspection Mode Clearing (650 V-Twin) Every 100 hours, the word BELT will appear to alert for inspectionSee
the 4-pin connector and the belt indicator switch connector; then turn the ignition switch to the ON positionThe belt indicator
should go off 2Use the multimeter and select the ohms function; then measure resistance as follows: pins (red)(black), 3-15
ohms; pins (orange)(blue), 3500-6500 ohms; pins (yellow)(blue), 630-5330 ohmsIf readings are not as specified, replace the
engine brake actuator ATV2143A Engine Brake Actuator Resistance (650 V-Twin) NOTE: This component is located on the V-belt
cover and controls drive clutch disengagement through lever linkage Engine Brake Controller Power Supply Voltage (650 V-Twin)
NOTE: This component is located under the seat and controls and drives the engine brake actuator through microprocessor which
processes data from the forwardreverse detecting sensor and from the speed sensorNOTE: For the following tests, make sure
the battery is fully chargedNOTE: Needle adapters will be required on the multimeter leads as these tests are made with the