2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 425Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 425

1Select DC Voltage on the multimeter (B); then turn the ignition switch ON2In the brake controller (A), connect the red tester
provides vehicle direction data to the engine brake controller ! CAUTION ATV2144 Always disconnect the battery when performing
resistance tests to avoid damaging the multimeter Controller-to-Engine Brake Actuator Voltage (650 V-Twin) 1Disconnect the
sensor lead wire connector (A); then select OHMS on the multimeter and check resistance between the sensor pinsThe meter
should read 1200-1600 ohms2Check each lead of the sensor to groundThe meter should show an open circuit or infinity (4)If
either test fails, replace the sensor (B) 1Support the ATV on stand or suitable jack so the wheels are off the ground; then
select DC Voltage on the multimeter (B)Connect the red tester lead to the brownwhite wire terminal (15) and the black tester