2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 438Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 438

6On the 650 V-Twin, install the input shaft into the pinion housing; then secure in the bearing with circlip Disassembling
cap screwsTighten to specificationsNOTE: If new gear case housing is being installed, tighten the cap screws to 3.5-4.3 kg-m
(25-31 ft-lb) NOTE: This procedure can be performed on rear gear case 1Using T-40 torx wrench, remove the cap screws securing