2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 444Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 444

2Using propane torch, heat the area surrounding the needle bearing to soften the Loctite 11Making sure the O-ring is properly
Removing Needle Bearing NOTE: Removing the needle bearing is rarely necessaryAvoid removing the needle bearing unless the
bearing is clearly damagedNOTE: This procedure can be performed on rear gear caseCC887 1Place 6.35 mm (14 in drill bit on
the inside surface of the needle bearing (against the bottom side); then drill through the pinion shaft needle bearing housing