2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 449Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 449

7Using side-cutters (or suitable substitute), remove both outside boot clamps from the shaftNote the position of the different-sized
drive axle must be replaced as an assemblyATV-1052 6Using side-cutters (or suitable substitute), remove the small clamp from
the shaft NOTE: Grease Pack (pn 0441-173) contains 120 grams of greaseThe inside joint (double-offset) requires approximately
70-90 grams of grease and the outside (bell-type) requires approximately 35-55 gramsWhen replacing boots, use 23 of the pack
for inside boots and 13 of the pack for outside boots ! CAUTION Do no over-fill the joint as boot damage may occur resulting
in joint failure 9Slide the new outside boot onto the shaft with the new clamps positioned as shownNote the different-sized