2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 451Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 451

NOTE: Pull the bearing ring out of the housing until it contacts the circlip; then slide the ring in half wayThis will purge
being correctly positioned on the shaftINSTALLING REAR DRIVE AXLE (Fully Independent Suspension) 1Position the drive axle
in the gear case and steering knuckle; then insert the upper A-arm ball joint into the steering knuckleSecure with cap screw
tightened to specifications2Place the brake hose into position on the upper A-arm; then secure the lower shock eyelet to
the A-arm with cap screw and new lock nutTighten to specifications3Secure the tie rod to the steering knuckle with new lock
nutTighten securely; then install and spread new cotter pin4Slide the hub wbrake disc into position in the steering knuckle
followed by washer and hex nutTighten finger-tight at this time5Install the brake caliper on the steering knuckleTighten
to specifications; then pump up the hand brake lever and engage the brake lever lock6Tighten the hub hex nut (from step 4)
to specifications; then install and spread new cotter pin making sure each side of the pin is flush to the hub nut6-23 1Slide