2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 456Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 456

6Install the wheels and tighten to specifications7Remove the ATV from the support standNOTE: Check all fasteners for tightness
Drive Axles in this section)3Remove the four cap screws securing the engine output shaft to the rear gear case input flange
2Secure the engine output shaft to the rear gear case input flange with three cap screws (coated with red Loctite #271) and
lock nutsTighten to specifications3Install the rear drive axles (see Drive Axles in this section)4Install the left-side rear
A-arms (see Rear A-Arms in Section 7) REMOVING 1Secure the ATV on support stand to elevate the wheel; then remove the wheel
4Remove the two cap screws and lock nuts securing the rear gear case to the frame; then remove the gear case through the