2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 492Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 492

3Remove the two cap screws and lock nuts securing the cargo box to the frame; then remove the cargo box and discard the lock
is necessary 2Measure the distance from the floor to the mid-point of each headlight3Using the measurements obtained in step
2, make horizontal marks on the aiming surface4Make vertical marks which intersect the horizontal marks on the aiming surface
directly in front of the headlights5Switch on the lightsMake sure the HIGH beam is onDO NOT USE LOW BEAM6Observe each headlight
beam aimProper aim is when the most intense beam is centered on the vertical mark cm (2 in below the horizontal mark on the
aiming surface 1Clean all cargo box components with soap and water2Inspect the cargo box for cracks, tears, and loose mounting
hardware3Inspect the welds of the cargo box frame for cracking or bending4Inspect the cargo box gate latches for smooth operationINSTALLING
1Place the cargo box into position on the frameSecure with cap screws and new lock nutsTighten to specifications ATV-0070