2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 493Get this manual

2006 Arctic Cat ATVs 400/400TBX/400TRV/500/500TBX/500TRV/650H1/650 V-Twin Service Manual, Page 493

2Inspect all wires for corroding, pinching, and cracking3Inspect the bulb for wattage, voltage, and proper operationINSTALLING
seat should automatically lock into positionREMOVINGINSTALLING (400 FISVP) 0732-336 REMOVING 1Unplug the three-prong connector
and free the taillight wiring harness from the frame2Remove the torx-head cap screws securing the taillight assembly to the
frameAccount for any washers3Remove the taillight assemblyINSPECTING NOTE: Whenever part is worn excessively, cracked, or
damaged in any way, replacement is necessary 1To remove the seat, pull the seat lock lever backward (located under the rear
rack between the storage compartment and the frame)Raise the rear of the seat and slide it rearward2To lock the seat into
position, slide the front of the seat into the seat retainers and push down firmly on the rear of seatThe seat should automatically
lock into positionREMOVINGINSTALLING (TRV) 1To remove the rear seat, pull the two latch handles to the rear and rotate them