2006 Arctic Cat ATVs factory service and repair manual, Page 15Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 15

3Remove the vent plugs; then (if necessary) fill the battery with distilled water to the upper level indicated on the battery
the battery, make sure the ignition switch is in the OFF position 6Place the battery into position in the ATV and secure
with the hold-down bracket 7Attach the vent tube and check the vent tube to make sure it is not crimped or obstructed in
any way and that it is properly routed through and secured to the frame8Connect cables to the proper terminals: positive
cable to the positive terminal (+) and negative cable to the negative terminal (-1Connect the negative cable last 400 FIS