2006 Arctic Cat ATVs factory service and repair manual, Page 27Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 27

7Apply oil to new filter O-ring and check to make sure it is positioned correctly; then install the new oil filterTighten
the threads touch engine casel NOTE: On the 400 auto1500 auto1650 14Inspect the area around the drain plug and oil filter
for leaksSTRAINER 1 NOTE: For servicing the oil strainer on the 650 V-Twin, see Center Crankcase Components in Section 3
HI, the oil level stick should not be threaded into the case for checking the oil levelOn the 650 V-Twin, the oil level stick
should be threaded into the case for checking the oil leveli NOTE: To check the oil strainer, use the following procedure1Remove
the skid plate2Remove the cap screws securing the oil strainer cap; then remove the capAccount for the O-ring 13Remove the
oil level stick; the engine oil level should be above the illustrated "L" mark but not higher than the illustrated "F" markA
CAUTION Do not over-fill the engine with oilAlways make sure that the oil level is above the "L" mark but not hiaher than