2006 Arctic Cat ATVs factory service and repair manual, Page 32Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 32

TAILLIGHT-BRAKELIGHT To replace the taillight-brakelight bulb, use the following procedure1Turn the bulb socket assembly
the housing and turn it clockwise to secure CHECKINGIADJUSTING HEADLIGHT AIM The headlights can be adjusted vertically and
horizontallyThe geometric center of the HIGH beam light zone is to be used for vertical and horizontal aiming1Position the
ATV on level floor so the headlights are approximately 6.1 (20 ft) from an aiming surface (wall or similar aiming surface)1NOTE:
There should be an average operating load on the ATV when adjusting the headlight aim Switches Each time the ATV is used,
switches should be checked for proper operationUse the following list for referenceAIgnition switchengine will start 2Measure
the distance from the floor to the mid-point of each headlight BEmergency stop switchengine will stop 3Using the measurements