2006 Arctic Cat ATVs factory service and repair manual, Page 36Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 36

2Making sure the brake pedal is fully released and against the stop, check that the holes in the push-rod actuator align
the reservoirIf the level in the reservoir is not visible in the sight glass, add DOT brake fluidSight Glass- 1 NOTE: If
the holes align, no adjustment is necessary; proceed to step 4 3If the holes are not aligned, loosen the upper nut and rotate
the push-rod and lower nut until the holes align; then hold the actuator and lower nut and tighten the upper nut securely