2006 Arctic Cat ATVs factory service and repair manual, Page 37Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 37

1 NOTE: During the bleeding procedure, watch the reservoir sight glass very closely to make sure there is always sufficient
end into container; then while holding slight pressure on the brake lever, open the bleeder screw and watch for air bubblesClose
the bleeder screw before releasing the brake leverRepeat this procedure until no air bubbles are present 4Carefully check
the entire hydraulic brake system that all hose connections are tight, the bleed screws are tight, the protective caps are
installed, and no leakage is present i nyarauiic Drake system is designed TO use DOT brake fluid onlyIf brake fluid must
be added, care must be taken as brake fluid is very corrosive Ito ainted surfacesI INSPECTING HOSES Carefully inspect the
hydraulic brake hoses for cracks or other damageIf found, the brake hoses must be replacedCHECKINGIREPLACING PADS The clearance
between the brake pads and brake discs is adjusted automatically as the brake pads wearThe only maintenance that is required