2006 Arctic Cat ATVs factory service and repair manual, Page 38Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 38

3If thickness of either brake pad is less than 3.2 mm (0.125 in, the brake pads must be replaced1 NOTE: The brake pads should
system five times until brake pads are burnishedCInstall the new brake padsDSecure the caliper to the knuckle andlor axle
housing with the cap screwsTighten to specifications Adjust the auxiliary brake (if necessary)Verify that the brakelight
illuminates when the hand lever is compressed or the brake pedal is depressed Coolant (5001650 1650 V-Twin) The cooling system
should be inspected daily for leakage and damageAlso, the coolant level should be checked periodicallyWhen filling the cooling
system, use premixed Arctic Cat Antifreeze (pln 0638-395)While the cooling system is being filled, air pockets may develop;
therefore, run the engine for five minutes after the initial fill, shut the engine off, and then fill the cooling system