2006 Arctic Cat ATVs factory service and repair manual, Page 41Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 41

1 NOTE: Before removing the belt, note the markings (A) (or mark the belt using tape or marker) in order to reinstall in
Belt Gauge (pln 0444-177 (B) and calipers Be sure to install the three bolts in the specified positions or the tapped holes
will be damaged 4Remove the drive clutch cap screw (C) (left-hand threads) and account for two washers and stepped washer5Remove
the drive clutch (C) from the crankshaft using an appropriate clutch puller tool (B) and turning it clockwise while holding
the drive clutch-with the drive clutch holder (A) 2If belt width is below the service limit of 28.8 mm (1.13 in or there
is damage to the belt, it must be replacedINSTALLING 1 NOTE: Be sure to install the belt in the same direction as originally