2006 Arctic Cat ATVs factory service and repair manual, Page 42Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 42

1 NOTE: Make sure the belt is at the top of the driven pulley (A) before checking belt deflection 4Disassemble the driven
For each 0.1 mm (0.004 in of shim pack change, belt deflection will change by approximately 1.45 mm (0.057 inShims are available
in the following sizes: 0.6 mm (0.024 in, 0.8 mm (0.031 in, 1.0 mm (0.039 in, and 1.4 mm (0.055 in 7Assemble the driven pulley
(see Section 3, Servicing Right-Side Components, steps 1-5); then install the driven pulley, V-belt, and drive clutch and
verify that belt deflection is within specifications1 NOTE: If belt deflection is out of specifications, proceed to step
3If belt deflection is within specifications, proceed to step 8 8Check the position of the Belt Failure Detection Switch