2006 Arctic Cat ATVs factory service and repair manual, Page 43Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 43

10Connect the actuator lead and the Belt Failure Detection Switch lead; then install the air duct and secure with the clamps
(see Section 5) must be performed To adjust the cable, use the following procedure: 1Locate the in-line adjuster on the cable
near the differential lock lever; then slide the rubber boot (A) off the adjuster and loosen the jam nut (B) 9Install the
cover seal into the V-belt cover with the glue joint (A) as shown; then install the V-belt cover and tighten the cap screws
to specifications 2Turn the adjuster (C) until approximately 6.35 mm (114 in of free-play can be measured at the end of the